Internal login

When you configure the Ricoh ESA Unified Client to do internal login, it is integrated with the built-in login of a device.

Login

Depending on the setting for Enhanced Authentication Management, the user sees either of the following two login screens:

Figure 1. Enhanced Authentication Management set to OnLogin with Enhanced Authentication Management set on
Figure 2. Enhanced Authentication Management set to OffLogin with Enhanced Authentication Management set off

In either case, the Ricoh ESA Unified Client supports both user name and password and card swipe login for a card ID already registered. A card swipe is ignored if the card ID is not already registered.

Logout

The user can log out by pressing Login/Logout on the device panel at any time, even when the Ricoh ESA Unified Client is not the active application. The device shows its login screen again after the user has logged out.

There is no automatic logout when the Ricoh ESA Unified Client is configure for internal login. The autoLogoutTime setting is ignored.